lock chamber

英 [lɒk ˈtʃeɪmbə(r)]

美 [lɑːk ˈtʃeɪmbər]

网络  闸室

英英释义

noun

• enclosure consisting of a section of canal that can be closed to control the water level
  Synonym:lock

双语例句

• Technical measures taken for the Zaohe3rd lock chamber are discussed in view of the construction characteristics and thorny problems and according to the construction procedure.
  针对皂河三线船闸闸室施工特点、难点，依据闸室施工工序，提出了应采取相应技术措施施工。
• This paper introduces the technology of anti-seepage treatment on structural joints in the fourth lock chamber northern in TGP's permanent lock, mainly states the technique and material used in project as well as construction process.
  本文介绍了三峡永久船闸北线四闸室结构缝防渗处理工程中处理的工艺、使用的材料、施工的过程。
• The Analyses and Research on the Ultimate Bearing Capacity of Soil Layer Anchor Rod in Lock's Chamber Structure
  船闸工程土层锚杆的变形及设计承载力分析研究
• Investigations on the oxygen contamination in the μ c-Si ∶ H thin films deposited by very-high-frequency plasma-enhanced chemical-vapor deposition ( VHF-PECVD) technique with and without load lock chamber have been reported in this paper.
  对不同的本底真空条件下，采用甚高频等离子体增强化学气相沉积技术沉积的氢化微晶硅（μcSi∶H）薄膜中的氧污染问题进行了比较研究。
• Discussion on lock gate superimposing float chamber
  船闸闸门增设浮箱问题的探讨
• Load articles to be sterilized then close and lock the chamber door.
  放入要灭菌的物品，关闭并锁上锅盖。
• The realizable κ~ε turbulent model was used to carry out the unsteady calculation about the simulation system which was composed by batch handling lock hopper and scrubbing cooling chamber. The result of numerical simulation agrees well with the operation value.
  在由间歇排渣型锁斗和洗涤冷却室组成的模拟系统中，应用Realizableκ~ε湍流模型进行了非稳态计算，得到的计算结果和实际情况比较吻合。
• Being a sophisticated spatial structure system conventional methods in mechanics of materials and structural mechanics find difficulty in describing the real burdening situation of lock chamber, and presents embarrassment in designing.
  泄水闸室属于一种复杂的空间结构，传统的材料力学和结构力学方法计算难以真实的反映其受力状态，必然给设计工作带来一定的困难。
• Horizontal displacement moves to the ship lock chamber, the maximum deformation is 26.14 mm. With the end of excavation the deformation approximately trends to be stable, and at present the deep rock mass of high slope is in the steady condition.
  岩体水平向位移表现为向闸室方向，最大变形为26.14mm，随着开挖的结束，变形基本趋于稳定，目前高边坡深层岩体处于稳定状态。
• Application of Monte-Carlo Method in Reliability Analysis against Sliding for Gate Lock Chamber
  蒙特卡罗法在水闸闸室可靠度分析中的应用